1、Insert the disk labeled “System & Application Software” into the DVD ROM drive.插入我们上面提到的软件盘到dvd光驱里
2、Properly turn off the scanner by momentarily pressing the Power On/Off Switch. Select “Shut Down” from the System Exit menu正常关闭设备开关 然后从弹出的菜单中选择 “Shut Down（关机）”If the system will not shutdown normally, hold down the Power On/Off Switch until the light turns from green to amber如果系统不能正常关机 ，请按住电源开关键 大约30秒， 系统会强制关闭 ，指示灯会从绿色变为黄色。
3、Turn on the system. System will detect the DVD-RW automatically.打开机器，机器将会自动选自从DVD-RW运行Press any key to continue when below message display as shown below.直到显示器最下方出现“Press any key to continue”字样 说明机器已经读取光驱光盘的内容了，这是能否继续的关键
5、接着步骤4我们选一 会看见以下界面Press any key to continue when below message display as shown below.下面的消息显示“Press any key to continue”，如下图所示。
7、System updating finished,系统升级完成 就回出现 以下界面 如图
8、Press power key to reboot system, then remove the CDROM from the drive immediatel烤恤鹇灭y. When system first time boot up after upgrading complete, type Serial Number and Option Key before starting up重启彩超机器 拿出系统光盘 等待系统启动后 输入序列号和选项密钥注意：千万要备份好序列号和选项密钥 否则非常麻烦
